waste incinerator manufacturer in china

1. Burning rate: 250 Kg/hr.
2. It should be able to Operate not Less than 10 hours/day
3. This incinerator must be able to destruct all combustible wastes produced by hospitals, private clinics, laboratories, institutes, etc…
4. Design Specification: Types A, B, C, D, and E of medical waste
5. “PYROLYTIC” combustion, by controlling the gasification of waste.
6. The incinerator must avoid the release of black smoke and fine dust, (Smokeless) during the loadings.
7. It should be able to reduce the volume of wastes by 98%.
8. It should be able to hold emission in the second burn with gas residence of not less than 2 seconds.

The incineration should be wholly free from visible smoke in addition to offensive odours.

9. The lower calorific power (L.C.P) of this waste will be 3,500 kcal/kg

• The Temperatures of combustion:Minimum will be 850^oC and max 1400^oC
• Post combustion: >1100^o

10. The Internal diameter of the Chimney: Ø 400mm² and its height: 8 Meter
11. The Volume of the combustion chamber: Not Less Than 2.3 M³
12. Burner operation should be Automatic On/Off
13. Fuel : diesel, LPG, Natural Gas, Bio fuel
14. The supplier must provide  necessary information for the best of  the installation

This incinerator with”PYROLYTIC” combustion should have:

15. A combustion chamber of waste:

* Perfectly tight doorway for the manual loading of waste.The loading should be Manual, Batch Load,

* A burner of light that the use is restricted to the ignition of waste.

* Top Loading loading with door seals gone up on hinges, wheel of screw plug, flexible joint, and stuffing insulating out of refractory.

* The insulation of the combustion chamber ought to be composed of refractory bricks, having a high content of aluminum and insulates bricks in order to assure a minimum temperature on   the outside sheet metal.

* Composition of the refractory;

• Refractory concrete :
  • . Thickness : ≥100 mm
  • . Nature: 42% of Al203
• Insulate in fibrous panels :
  • . Thickness: ≥75 mm
• Nature: Calcium silicate.

* Burner of light of waste, with fuel, standard mono-bloc casting guiding plunging flame, lighting and safety of electronic ignition, permanent ventilation, electromagnetic sluice gate of regulation and isolating valve.

* Plate of combustion in Carborundum, preventing the fixing of glass and slags.

16. Load Method: Top Loading

17. A chamber of post combustion of gases

* A burner of combustion of gases,

* A device of injection of air allowing a entire recombustion of gases,

* A device of air ducts of cooling of waste gases,

* A sheath of evacuation of the gases burnt.

* Carcass in solid sheet steel with support of link.

* Composition of the refractory;

• Refractory concrete :
  • Thickness : ≥180 mm
  • Nature: 65% of Al203
• Insulate in fibrous panel :